Session Log: Clavinet


8/5/24

To record the clavinet sound off the digital keyboard I stuck to using DI (figure 1) however, I diverged from my original plan of a DI box instead using a bass amp with an XLR DI output (figure 2) this allowed me to add bass frequencies to the output resulting in a warmer tone (figure 3).



Figure 1: The jack output on the keyboard.


Figure 2: The jack input and XLR output of the amp.


Figure 3: The settings used on the bass amp.


Each of the 8 recorded tracks then went through the studio wall box (figure 4) and got routed through to a Neve 1073DPA preamp (figure 5), adding some light analogue distortion in the highs, adding saturation and harmonics to the sound (figure 6).



Figure 4: bass amp output entering the wall box input.


Figure 5: The signal getting routed to the Neve preamp.


Figure 6: Settings used on the Neve preamp.


Next the tracks routed through a Neve 1073LB EQ and DL441 compressor (figure 7). The EQ reduces high frequencies around 4.8kHz to leave space for the vocals, with low boosts around 80Hz-200Hz to emphasise the warmth (figure 8) with two tracks however, the highs were reduced less and lows deemphasised creating a crisper sound simulating the processing on two of the clavinet tracks in 'Superstition' (figure 9).



Figure 7: Routing chain for this session.


Figure 8: EQ settings for the 6 primary tracks.


Figure 9: EQ settings for the 2 higher frequency tracks.


The compression applied utilises a moderate ratio at around 2:1 with a gentle threshold taking out some of the transient dynamics of these parts (figure 10).



Figure 10: Compressor settings used on all 8 tracks.


Reflection:

Overall this session went ok however, I feel there were some significant drawbacks.
  1. The abundance of 8 layered tracks creates an overall messy sound, so I reduced the amount in final version to 4.
  2. The EQs could have been better utilised and although help are quite extreme additionally I tidied the EQs up later on with  a plugin EQ in my daw (figure 11).
  3. The overall around just doesn't capture the spirit of the clavinet in 'Superstition' I feel.
  4. I ended up using a plugin delay instead of the Lexicon PCM92 reverb unit (figure 12)
Despite the drawbacks I feel the subtle compression was a good choice and the use of a bass amp improved the weight of the sound.



Figure 11: Digital plugin settings later added to the clavinet tracks.


Figure 12: Replika delay plugin used on two of the tracks.

Comments

Popular posts from this blog

Evaluation and Conclusion

Session Log: Synth

Initial stem and reference track choices